Manicure hood TUFI profi PREMIUM ND900PR desktop with filter and metal grid white 95 W

In salons where the main procedures are manicure and pedicure, most often in the air gets dust from the processing of artificial coatings on the nails. In order to avoid air pollution and to keep the office always clean and fresh manicure hoods are installed.

Hood TUFI profi PREMIUM ND900PR - a necessary device for any nail-master who uses a cutter. During manicure procedures, a huge amount of dust is generated, which affects the respiratory tract of the client and the master, and negatively affects health in general. Manicure extractor is a convenient, powerful device will save cleanliness both at the workplace of an amateur and a master-professional. Hood TUFI profi PREMIUM has a special shape, the client will be able to put your hand on it when carrying out build-up or decorative treatment, which is very convenient. The body of the hood is made of quality materials, the grate is made of metal. Hood-vacuum cleaner structurally consists of: a closed case with a rotary switch on/off and adjusting the speed of rotation of the motor, with a built-in centrifugal fan, the blades of which are protected by a removable grille; power cord; HEPA-filter for dust collection.

Completion:

• Hood 1pc.
• HEPA-filter for dust 1pc.
• Instruction manual 1pc.
• Power cord 1 pc.

Characteristics:

Instructions for use:

1. Install the filter inside the hood before starting work;
2. Place the hood on the table surface and plug it into the socket;
3. Place the client's hands on the manicure hood and start the procedure;
4. After the work is completed, the device should be turned off.

Recommendations for the most efficient operation

It is necessary to control the speed of your cutter to 15-20 thousand revolutions on gel-lacquer, gel, as well as depending on the abrasiveness of the cutters used. Hard notches of cutters also require reduction of revolutions, as they make big chips! In case of non-compliance with the "speed modes" it is possible to scatter sawdust, large glitter flying off the cutter, peeling, etc. Very IMPORTANT is the position of the hands of the master and the client. Do not expect maximum results by blocking the dust collection hole with your hands. The client's hand should be kept as close as possible above the safety net.

Safety precautions

• It is forbidden to use a wet or damp filter in work.
• Do not kink the power cord for reliable operation.
• Do not insert fingers or other objects into the protective grid when the fan is running.
• Disconnect the power by directly holding the plug, having first turned the power on at the rotary switch.
• Contact the supplier or manufacturer in case of any malfunction.

Operating and safe use of the hood

Before switching on the hood, it is necessary to install a filter to collect dust and small particles inside the hood. For this purpose, there is a slit in the front of the hood, on the side of the switch switch, which is accessible for manipulation. It is strictly forbidden to switch on the hood without the filter installed. This may damage the motor or injure the user. The unit is switched on after connecting the supplied power cord to the socket and using the rotary switch on the front of the hood. Turn the switch clockwise to position I (medium power) or II (maximum power), to change the RPM speed and suction power. By turning the switch counterclockwise, you can reduce power or turn off motor operation by moving the switch to the left-most position. For the most efficient and reliable operation of the device, it is recommended to clean the filter at the end of the working day or after every 2-3 treatments. It is cleaned by pouring out the products of work, or clean the inside of the filter with a vacuum cleaner. The filter can be gently washed or treated with disinfectant, but must not be used wet. The filter should be replaced with a new one at least once every 2-3 months.